Subject 325
Bulletin Dated: December 5, 2017
SUMMARY OF TOPICS
The following topics were discussed at the meeting of the Standards Technical Panel for Door, Drapery, Gate, Louver, and Window Operators:
1. Constant Pressure Override Capability for Gate Operators Using Portable Wireless Controls
2. Barrier Arm Manual Release Exception
3. Swing Gate Entrapment Zone
4. Remove Maximum 2 Seconds Gate Reversing
5. Class I and II Limiting gate speed
6. Licensing To Purchase Gate Operators
7. Swing Gate Entrapment Zone Definition and Instruction
8. Exception Class I Pedestrian Gate Use
9. Use of Placards on Class I Installations
10. Adding Class IA
11. Addition of Class IS
12. Expansion of Gate Operator Class Types for Installation
13. Require a Usable “Emergency Release,” Not Just a “Means for Manual Operation” for Gate Operators
14. Slide Gate Entrapment Zone - Clarifications
15. Change to Introduction Scope
16. Specific Requirements for Window Operators and Systems
17. Residential Garage Door Operator with Power Supply Cord
18. Removing Type AF and CF Wiring, and Editorial Revision to 15.1.5
19. Propose an Alternate Method for Providing Ground Fault Circuit Interrupter Protection for Convenience Outlets on Appliances
20. Proposal for Button Battery Requirements to be Included in UL 325, Reference to Horizontal Standard, UL 4200A
21. Outdoor Use Clarification of Edge Sensor Testing
22. Requirements for Lasers
23. Limit Upward Force, or Add an External Entrapment Device for Use in the Upward Direction for Commercial Garage Doors
24. Opto Electronic Sensors
25. Unattended Operation Accessory - Light Output
26. Unattended Operation - Alignment of Requirements
27. Battery-Powered Door, Gate, and Window Operators
28. Temperature Test Clarifications
29. Edge Sensor Endurance Test Force Clarification
30. Drapery and Window Blind Operators and Systems
31. Emergency Override Proposals
32. IEC Harmonization
33. UL 5500 - Remote software downloads